More Than 3000 Kinds Of Materials Need To Be Dried! Air Source Heat Pumps Ride The Wave.

The key to material drying effect is in the process. The heat pump drying process is to dry materials to the required moisture content by precise control of temperature and humidity in the drying room.
At present, there are about 3,000 kinds of materials to be dried in China, of which there are more than 700 kinds of common materials. These materials are roughly divided into six categories: flowers and leaves, fruits, roots and stems, meat and poultry, aquatic products and industrial categories. Each material has its own different drying characteristics, so the drying process is also different.
In the development of drying process, to fully consider the material form, pretreatment process, material drying characteristics. The same drying room and drying unit for drying the same material, the use of good drying process can be in a shorter period of time to dry the outstanding, aroma and flavor of high-quality products, and the use of bad drying process may not be able to dry the material, drying bad quality, or drying time is too long, energy consumption is too high.
Take noodle drying as an example. Noodles is a need for more rapid drying and dehydration of materials, in the drying process, temperature control is very critical, if the temperature is too high, will make the noodles break, too low will make the noodles sour, sticky, will affect the quality of noodles. A food company's single production line noodle processing capacity of about 30 tons per day, the output is large. The original drying method is gas boiler drying, Airsour after many communications and field research, according to the drying demand and the characteristics of the noodle drying, tailored for the company's noodle drying solutions. In this drying project, 4 sets of 50 HP air source heat pump drying units were installed, and the noodles were dried in sections by constant temperature and humidity process. Since the units have been put into use, the drying effect is better than before the renovation, while the Airsour air source heat pump drying units have high energy efficiency and stable operation, which reduces the operation cost by nearly 50% compared with that before the project renovation.
Airsour air-source heat pump drying unit has no exhaust gas and heat emission, no noise pollution, and can replace the traditional steam, electric heat, hot air and other drying to fully meet the drying needs of various products. With advanced ventilation and air inlet drying system design, the drying process can reach the standard of one kind of sanitary condition and apply to the export level requirements. Using Qihao technology air source heat pump drying unit can save more than 40% cost compared with coal-fired method, and save more than 60% cost compared with fuel oil and electric heating. Unique intelligent automatic control system can be customized according to the products with different temperature drying curves (variable temperature drying), with stable, uniform and good quality drying conditions. Safety, set phase sequence protection, phase failure protection, overload protection, high voltage protection, low voltage protection and other multiple safety protection functions, so that customers can buy at ease, use at ease.